Permanent Security Fencing

Variants

Solutions in the system

3D pressed panel

Stiffened by pressings, the default choice for industrial sites.

2D twin-wire panel

Two horizontal wires, higher rigidity and cut resistance.

Welded mesh rolls

Economical fencing for long runs and internal zones.

Grating panels

Technical enclosures and guards within installations.

Posts and plinths

Posts for concreting or on base plates, precast plinths under the panel.

Screening inserts

Reduced visibility and wind load on runs next to buildings.

Gabions

Stone-filled baskets: boundary, structure and acoustic screen in one.

Retaining walls

Stabilising slopes and level changes along the fence line.

Sliding and swing gates

Entry points sized for vehicle traffic and on-site automation.

About this category

Industrial fencing: how the system is built and chosen

A permanent perimeter rests on three elements: the infill, the post and the founding method. The infill is usually a welded panel, either pressed (3D) or twin-wire (2D), with wire diameters chosen for the required stiffness. Posts are either concreted into the ground or fixed on base plates anchored to existing slabs.

The category covers 3D and 2D panels, welded mesh in rolls, grating for technical enclosures, screening inserts and mats, posts together with precast plinths, and gabions and retaining walls where the boundary also has to work structurally or damp noise. Sliding and swing gates matched to the fence line complete the system.

Selection depends on the required protection level, height, ground conditions and working environment. 2D panels are chosen above two metres and where cutting is a real risk; 3D suits typical industrial sites. It pays to prepare the fence for a future protective topping by choosing posts that will accept a bracket.

Product range

Products in this category

Applications

Where it works

Manufacturing plants and industrial parks

Warehouses, logistics centres and manoeuvring yards

Energy and water facilities

Equipment yards, storage sites and transfer points

Sites needing a durable boundary with entry control

Replacement of worn fencing along the same line

Build and specification

What the quotation confirms

Fence height and wire diameters for the required protection level

Hot-dip galvanizing plus powder coating in a RAL colour

Post founding: pad foundation or anchored base plate

Readiness for anti-climb extensions and razor wire

Compatibility with the existing fence line when extending

Section drawings and a material schedule for the design

FAQ

Frequently asked questions

2D or 3D panels?

3D is enough for a typical industrial site. 2D is chosen where rigidity matters, above two metres of height, and where cutting attempts are a real risk.

Can top protection be added later?

Yes. We select posts that will accept an extension or bracket, so reinforcement can be added without replacing the fence.

When a gabion instead of a fence?

When the boundary also has to stabilise a slope, damp noise or provide mass. Otherwise a panel is cheaper and faster to install.

We will design a permanent perimeter for your site.

Send the run length, site conditions and deadline, and we will come back with a configuration and a quotation.

Request a Quote Talk to the team