Layers of the system
Outer perimeter
Higher-rigidity panel fencing along the whole site boundary.
Protective topping
Brackets, concertina and razor mesh on higher-risk stretches.
Controlled entry
Gates, airlocks and blocking bollards at entry points.
Internal separation
Enclosures for switchgear, tanks and technical zones.
Equipment protection
Cages and covers for individual devices and cabinets.
Overhead protection
Covers limiting risks from above on defined sections.
Protecting a critical facility: the layer model
At critical facilities a single product does not solve the problem, because risk is not spread evenly. An effective layout rests on layers: the perimeter boundary, its topping, controlled entry, internal separation and protection of individual equipment. Each layer answers a different scenario and can be introduced on its own.
The category covers higher-rigidity panel fencing, toppings with brackets, concertina and razor mesh, gates and entry airlocks together with blocking bollards, enclosures for switchgear, tanks and technical zones, cages for equipment and cabinets, and covers limiting risks from above on defined sections.
The protection level is set separately for each boundary section, because risk concentrates at rear boundaries, laydown areas and places with poor visibility. Works are phased so the facility keeps operating, and material documentation should be usable directly in the scope of works for a tender.
Products in this category
Where it works
What the quotation confirms
Frequently asked questions
Where do we start?
Can a site be reinforced in stages?
Do you prepare tender documentation?
We will set out the protection layers for your facility.
Send the run length, site conditions and deadline, and we will come back with a configuration and a quotation.